HOW TO MAKE OUTPUT WAVEFORM OF CLAMPER CIRCUIT

CLAMPERS

Rules to find the out put wave form of clamper

1. check the battery in the circuit from the upper terminal of the input (as in clippers)

• if positive terminal of the battery is found first draw a line on the +v volts.
•  if  negative terminal of the battery is found first draw a line on the -v volts.

     2. check the diode from the upper terminal of the output

• if we get n side put the lower most end of the input waveform on the line drawn.
• if we get p side put the upper most end of the input waveform on the line drawn.

we have drawn the out put waveform of the clamper circuit.

HOW TO MAKE OUTPUT WAVEFORM OF CLIPPER

clipper of  basic  electronics

     rules for writing output

1. see battery in circuit  from upper terminal of input

•  if we get positive terminal draw a line at +v volts on input signal
• if we get negative terminal draw a line at  -v volts on input signal

   2. see the diode in circuit from upper terminal of output

• if  p side comes delete the upper part of the input signal from the line we drawn above.
• if  n side comes delete the lower part of the input signal from the line we drawn above.

  3. now see , circuit is series clipper or parallel  clipper

• if it is a parallel clipper draw the remaining waveform as oparlleutput.
• if it is a series clipper bring the line we drawn to the x axis, and draw remaining waveform as out put

       we can draw any clipper problem in this way.